VR Turning v1.21 released

Help and advice for Denfords lathe control software VR Turning.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

VR Turning v1.21 released

Post by Denford Admin » Tue 09 Jun , 2009 13:43 pm

v1.20 - 17/4/2009 added newturn270NS (auto turret) and newturn270MNS (manual toolchange)
v1.20 - 17/4/2009 fixed bug where controltype 11 was set (11 is not used as type 9 will find a ROHS board and select 55xx automatically)

v1.21 - 29/4/2009 added comms 56 to do a single thread pass in Z for G32 lines - all mints needed to be changed as well (52xx 55xx only)
*this fix is required for QuickTURN 2D Design threading to work*
v1.21 - 9/6/2009 changed Newturn270 mints (55xx, orange Baldor only) to improve reaction time of feed/rev mode

as usual, check here to download the latest version:
http://www.website.denford.ltd.uk/suppo ... -downloads

Post Reply