Baud Rate Number Unsupported

Help and advice for Denfords lathe control software VR Turning.

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Baud Rate Number Unsupported

Post by Denford Admin » Fri 17 Apr , 2009 15:03 pm

We have seen the error Baud Rate Number Unsupported when trying to connect to a USB compatible Lathe (eg Turn270, Novaturn, MicroTurn)

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Fri 17 Apr , 2009 15:06 pm

I've found out that this happens (and will then continue to happen) if you try to connect the VR Turning software to a machine that it can't find (eg, the USB cable has been pulled out, or the machine is switched off)

To fix it, go into Setup > machine parameters and under communcation settings set the control type back to 9 (it will probably be set to something else like 11)

This won't happen in the next release of VR Turning v1.20 :)

Post Reply