Thread cutting on Mirac lathe
Posted: Thu 13 Nov , 2008 0:18 am
I'm having problems getting a good quality thread and I've been playing about with it, but to no avail. I was wondering if the spindle speed and feedrate overide controls need to be on a certain setting to ensure that they are synchronised, or does the software take care of that automatically?
I've left the tool data set on a default setting and wondered if I need to change anything there?
Any help gratefully received,
Wheezy
I've left the tool data set on a default setting and wondered if I need to change anything there?
Any help gratefully received,
Wheezy