0 Feed Rate

Help and advice for Denfords lathe control software VR Turning.

Moderators: Martin, Steve, Mr Magoo

Post Reply
msustudent
Posts: 2
Joined: Thu 03 May , 2007 18:13 pm
Location: Morehead, Ky

0 Feed Rate

Post by msustudent » Mon 04 Jun , 2007 15:22 pm

I have a Microturn 2000 and VRTurning Version 1.16.2.425. I was turning a piece of aluminum stock and took to big of a cut now my feed rate is 0% and when I try to turn a piece my spindle starts but the tool does not move. Do you have any suggestions to what the poblem is.

Thanks
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Tue 05 Jun , 2007 7:57 am

Does the axes HOME Ok ?
Top
msustudent
Posts: 2
Joined: Thu 03 May , 2007 18:13 pm
Location: Morehead, Ky

Post by msustudent » Tue 05 Jun , 2007 20:42 pm

Yes, it homes just fine. It turns out that the feedrate knob on the front of the lathe was turned down. All I had to do was turn the knob up and that solved my problem.

Thanks for the help.
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Wed 06 Jun , 2007 14:11 pm

:oops: :oops: :oops:
Top
Post Reply

Return to “VR Turning - All Versions”