There is a new version of VR Turning
The machine type selected is checked against machine type that the card is programmed with.
The connection to the machine uses the latest DLLs from ABB/Baldor.
This can be downloaded from the address : http://www.denfordata.com/downloads/vrturningv1_49.zip
Help and advice for Denfords lathe control software VR Turning.
1 post • Page 1 of 1
- Denford Admin
- Site Admin
- Posts: 3586
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
- Location: Sunny Brighouse