Mitsubishi RV-M1 problem (LED 3 - Emergency Stop)
Posted: Mon 07 Mar , 2011 13:42 pm
Hi everyone,
As part of a project I am currently involved in we need to utilise a Mitsubish RV-M1 in conjunction with the Denford virtual reality software.
The current network setup consists of x3 Mitsubishi RV-M1 robots in network to a series of computers. These are connected to one emergency stop button. I am having problems with our Mitsubishi RV-M1 movemaster.
LED 3 keeps coming on indicating a drive unit emergency stop input according to the service manual. The manual further describes two possible causes. 1. The emergency stop switch on the drive unit front panel has been pressed or 2. The drive unit rear panel emergency stop switch is connected incorrectly.
The service manual describes two remedies. 1. Reset the emergency stop switch and 2. Check connection between the rear panel emergency stop terminal and the external switch.
We have checked connections, reset the emergency stop switches and everything seems to be in order but we continue to get this error which does not allow the robot to function it all.
Our next step will be to isolate the one robot and hopefully that should solve any problems we are having due to a simpler network but could someone please offer any advice on how to solve this problem?
Thankyou
As part of a project I am currently involved in we need to utilise a Mitsubish RV-M1 in conjunction with the Denford virtual reality software.
The current network setup consists of x3 Mitsubishi RV-M1 robots in network to a series of computers. These are connected to one emergency stop button. I am having problems with our Mitsubishi RV-M1 movemaster.
LED 3 keeps coming on indicating a drive unit emergency stop input according to the service manual. The manual further describes two possible causes. 1. The emergency stop switch on the drive unit front panel has been pressed or 2. The drive unit rear panel emergency stop switch is connected incorrectly.
The service manual describes two remedies. 1. Reset the emergency stop switch and 2. Check connection between the rear panel emergency stop terminal and the external switch.
We have checked connections, reset the emergency stop switches and everything seems to be in order but we continue to get this error which does not allow the robot to function it all.
Our next step will be to isolate the one robot and hopefully that should solve any problems we are having due to a simpler network but could someone please offer any advice on how to solve this problem?
Thankyou