Page 1 of 1

quickcam 3d line cut?

Posted: Sat 14 Apr , 2007 17:02 pm
by Rich
Hello,
can anyone tell me if it is possible to get quickcam 3d to line or pocket cut rather than raster cut ?
Thanks.

Posted: Mon 16 Apr , 2007 9:30 am
by Denford Admin
QuickCAM 3D (v3) is our basic 3D CAM package and will only ever do raster style plans
QuickCAM Pro is our higher featured CAM software, which has lots of machining options / styles, but retains the same easy to use wizard:
Area Clearance
Horizontal Area Clearance
Raster Roughing
Corner Offset Milling
Raster Finishing
Constant Stepover
Spiral Milling
Raster and Waterline combination milling
Base clearance Raster
Pencil Milling
Parallel Offset Pencil Milling
Waterline Milling