Raster cutting leaves marks around the edge
Posted: Thu 12 Oct , 2006 15:51 pm
We have a question with regards to the microrouter, will it do a profile cut around an object to clean off any machining marks left by the raster cutting?
We are probably missing a very obvious point in our attempts to learn how to drive it properly, but despite trying various machining plans, we cannot seem to make it go around the perimeter of an object when finishing, and so it's leaving us with a stepped finish on curved edges.
We are probably missing a very obvious point in our attempts to learn how to drive it properly, but despite trying various machining plans, we cannot seem to make it go around the perimeter of an object when finishing, and so it's leaving us with a stepped finish on curved edges.