Quickcam 3d plunging to full depth
Posted: Wed 14 Mar , 2012 13:26 pm
Hi
Im machining a 3d model in alluminium that is 4mm deep
No matter what I set the Max Cut (z) value in the tooling setup it always tries to do the whole 4mm depth in one pass.
using quickcam 3d ver 1.3.0.10
Thanks for any help
Paul
Im machining a 3d model in alluminium that is 4mm deep
No matter what I set the Max Cut (z) value in the tooling setup it always tries to do the whole 4mm depth in one pass.
using quickcam 3d ver 1.3.0.10
Thanks for any help
Paul