I have QuickCAM 3D V3.2. Will this work ok for milling out a CO2 dragster? I will use Inventor for drawing and save as an STL. Looks like it will pull the inventor drawings right in, just didn't turn on the Denford Router yet.
Thanks
QuickCAM 3D V3.2
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 4
- Joined: Mon 07 May , 2007 17:38 pm
- Location: State College, PA
The current version is 3.7
You can dowload the new version from,
http://www.website.denford.ltd.uk/suppo ... -downloads
Yes it is ok for the F1 dragster.
You can dowload the new version from,
http://www.website.denford.ltd.uk/suppo ... -downloads
Yes it is ok for the F1 dragster.
- Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Ron,
First get the latest version. Then go to help and tutorials.
There is a F1 R6 US tutorial that will take you through CAM and Manufacture. There is also a section on design using ProDesktop but just follow the tutorial from the stage where you save the STL file.
There is also an advanced guide you can read.
viewtopic.php?t=120
First get the latest version. Then go to help and tutorials.
There is a F1 R6 US tutorial that will take you through CAM and Manufacture. There is also a section on design using ProDesktop but just follow the tutorial from the stage where you save the STL file.
There is also an advanced guide you can read.
viewtopic.php?t=120