Page 1 of 1

UP! 3D Printer enclosure

Posted: Mon 03 Jun , 2013 12:13 pm
by j.zarzoso
Hi all,

Could anyone please suggest an enclosure to keep the temperature level without overheating the electronics?

Thanks!

Jaime

Re: UP! 3D Printer enclosure

Posted: Tue 04 Jun , 2013 9:24 am
by Denford Admin
There is a nice design here:
http://www.pp3dp.com/forum/viewtopic.ph ... ure#p13959
and another here:
http://www.thingiverse.com/thing:34032

You're right to worry about the electronics - I'd just make sure there is plenty of airflow through the bottom half of the UP!

Re: UP! 3D Printer enclosure

Posted: Thu 06 Jun , 2013 9:56 am
by j.zarzoso
Thanks for the info, much appreciated!

I could also find this option in plexiglass: http://www.thingiverse.com/thing:43859

Thanks again!