To help you dignose which top Baldor control card you currently have:
This is the Denstep top card which used to run with later DOS machines, and earlier Version 2 VR Milling machines.
Only has RS232 connection to maximum of 19200 Baud
Nextmove ST or Denstep Baldor Control Card
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Nextmove ST or Denstep Baldor Control Card
- Attachments
-
- This is what we call the DenStep top card with a RED seven segment LED display
- denstep-card.jpg (18.12 KiB) Viewed 4075 times
Last edited by Denford Admin on Fri 09 Feb , 2007 14:49 pm, edited 1 time in total.
-
Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
This is the newer (current) NextMoveST control card - green seven segment LED.
USB port was added to later versions.
Older software eg, Version 2 milling will have a machine name suffix NS
eg: MicroRouter NS
USB port was added to later versions.
Older software eg, Version 2 milling will have a machine name suffix NS
eg: MicroRouter NS
- Attachments
-
- This is the newer (current) NextMoveST control card - green seven segment LED.
- NextMoveST-502-card.jpg (21.79 KiB) Viewed 4074 times