Cable Diagrams

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Roy
CNC Expert
CNC Expert
Posts: 104
Joined: Tue 30 Jan , 2007 20:20 pm
Hardware/Software: 1986 Triac modified & running Mach 3
Location: Bucks, UK

Cable Diagrams

Post by Roy » Mon 05 Feb , 2007 20:55 pm

As i am not fully up to speed with wiring diagrams, could some one tell me on the 'IBM to TRIAC' drawing below.
What the 'loop' symbol from pin 2 on the 7 pin connector stands for.

Cheers
Roy 8)
Attachments
IBM-PNC3.JPG
IBM-PNC3.JPG (69.33 KiB) Viewed 6426 times
Top
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Post by bradders » Tue 06 Feb , 2007 8:23 am

Roy,

Its the interwoven metal screen wire that surrounds the other plastic coated cables. Therefore you want "Screened cable" to make up the final cable
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Tue 06 Feb , 2007 9:55 am

There was a bit of a discussion on this cable here:

viewtopic.php?t=596
Top
User avatar
Roy
CNC Expert
CNC Expert
Posts: 104
Joined: Tue 30 Jan , 2007 20:20 pm
Hardware/Software: 1986 Triac modified & running Mach 3
Location: Bucks, UK

Post by Roy » Tue 06 Feb , 2007 20:23 pm

Thanks, I was thinking that possibly could be the case. But best to check with you experts!

Cheers
Roy
Top
User avatar
Roy
CNC Expert
CNC Expert
Posts: 104
Joined: Tue 30 Jan , 2007 20:20 pm
Hardware/Software: 1986 Triac modified & running Mach 3
Location: Bucks, UK

Post by Roy » Fri 09 Feb , 2007 18:12 pm

Hi I have got some cable which has a foil shield, will this do the job?

Cheers
Roy
Top
Post Reply

Return to “Electronics”