Orac - "Total Steam Failure"

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
Chippy
Posts: 2
Joined: Fri 03 Mar , 2017 15:05 pm
Hardware/Software: ORAC CNC lathe circa 1991
Location: Hampshire UK

Orac - "Total Steam Failure"

Post by Chippy » Mon 13 Mar , 2017 11:46 am

My ORAC is now "Full Steam Ahead".
A very helpful guy on an American RC forum took up the challenge. We finally traced the problem to a faulty internal monitor and once disconnected everything works fine. I am using a external LCD connected to the rear panel video composite connection to see what's going on.

Post Reply