Break out board pins.

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
Bert
CNC Apprentice
CNC Apprentice
Posts: 56
Joined: Wed 13 Aug , 2008 13:29 pm
Location: maidstone uk

Break out board pins.

Post by Bert » Sat 06 Aug , 2016 10:39 am

Hi I have purchased a new 5 axis BOB.

I am converting a Denford microrouter to run MACH3,
I have purchased a break out board but it did not have indipendant GND conections for the stepper drivers.
I have at the moment conected them all to the GND where the 12-24 v goes.
Has any one had the same issues.
Bert
Attachments
bob board 1.jpg
bob board 1.jpg (88.26 KiB) Viewed 3287 times

Bert
CNC Apprentice
CNC Apprentice
Posts: 56
Joined: Wed 13 Aug , 2008 13:29 pm
Location: maidstone uk

Re: Break out board pins.

Post by Bert » Thu 11 Aug , 2016 19:08 pm

Got it working.
I have put them all in the gnd at the 12-24 v gnd pin.
It does work but I do wonder if I should put them in the PC-GND pin
Bert

Post Reply