Denford 2000 Blown Baldor Board

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
elchino
Posts: 1
Joined: Thu 19 May , 2016 13:51 pm
Hardware/Software: Denford 2000

Denford 2000 Blown Baldor Board

Post by elchino » Thu 19 May , 2016 14:02 pm

Hi all,
need your Denford 2000 input.
Have a Denford 2000 Mill.
The Baldor board burned out.
I want to replace it to make the axis spin again and the spindle work.
What will you recommend ?
Any comments highly appreciated
:)

pokerdetroit
Posts: 4
Joined: Mon 14 Oct , 2013 22:55 pm
Hardware/Software: Mircoturn and Micromill

Re: Denford 2000 Blown Baldor Board

Post by pokerdetroit » Thu 16 Jun , 2016 4:43 am

You could send the board to Digikey and have them repair it. I sent mine to Drive Controls in Toronto and they sent it to them.

Steve

Post Reply