Hi all,
On my microrouter pro, the x axis drive has stopped working, I have checked the voltage going to the drive which is good, I have swapped over the connector and fitted it to the y axis and the x axis motor moves fine, which tells me that there is an issue with the drive, there are no leds ON, when power is put to the drive either.
Where can I get the drive repaired or are there any replacement drives available.
Any help and advice greatly appreciated.
X axis drive failed
Moderators: Martin, Steve, Mr Magoo
-
Large519
- CNC Expert
- Posts: 101
- Joined: Wed 20 Mar , 2013 22:34 pm
- Hardware/Software: Denford Triac PNC3
FeatureCam - CADCAM
Delcam Powershape
Re: X axis drive failed
Is there a phone number at denford u can ring for repairs?