Z-axis jogging problem
Moderators: Martin, Steve, Mr Magoo
-
- Posts: 3
- Joined: Wed 07 May , 2014 12:34 pm
- Hardware/Software: MasterCAM X7
Denford Microrouter Compact
Techno-Isel LC router
Z-axis jogging problem
When I use the page up/page down buttons in the VR 5 interface to jog a Denford Microrouter Compact, it does not respond as it should. Sometimes, but not constantly, it will move correctly, then stop. Press the button again, and it will move the opposite direction. It is all over the place and it doesn't matter which button I am pressing and there seems to be no pattern to it. It's just completely random.