GE FANUC SERIES O-M 430 SERVO ALARM

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
denford jamil
Posts: 6
Joined: Wed 30 Oct , 2013 11:01 am

GE FANUC SERIES O-M 430 SERVO ALARM

Post by denford jamil » Thu 05 Dec , 2013 11:14 am

sir fist of all many thanks for providing me the parameters list.
i have entered all parameters according the list but i did not know how to call diagnostics on the control screen. second thing all previous alarms are cleared know but a new alarm message is appeared, i am sending you a photo of this new alarm.
i am waiting for a kind response.

thanks
jamil
Attachments
DSC01841.jpg
DSC01841.jpg (83.56 KiB) Viewed 7117 times

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: GE FANUC SERIES O-M 430 SERVO ALARM

Post by Martin » Thu 05 Dec , 2013 21:29 pm

You should have a button labled DGNCS/PARAM or similar that togles between parameters & diagnostics. You may need to be in Edit mode to change the values.

Salman
Posts: 1
Joined: Fri 10 Oct , 2014 13:06 pm
Hardware/Software: CNC Turning & Machining Centers
Controllers Fanuc and GSK

Re: GE FANUC SERIES O-M 430 SERVO ALARM

Post by Salman » Fri 10 Oct , 2014 13:09 pm

I have the same problem as pic attached By Mr. Jamil.

Kindly help me out.

Thanks
Salman

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: GE FANUC SERIES O-M 430 SERVO ALARM

Post by Martin » Fri 10 Oct , 2014 16:20 pm

Does the axis jump slightly when you power it up?

Also is the axis free to move? (Can you turn the motor pulley or leadscrew).

Post Reply