"-" on the Baldor 7 segment display
Moderators: Martin, Steve, Mr Magoo
- bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
"-" on the Baldor 7 segment display
I am getting a "-" on the Baldor 7 segment display when i try and boot up the machine tool
Last edited by bradders on Fri 29 Sep , 2006 7:24 am, edited 1 time in total.
- bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
For a Nextstep board (GREEN 7 segment display) "-" means that the Firmware is missing from the Baldor control board. Use the EASY UPGRADER utility found on out web site (www.denford.ltd.uk or www.denford.co.uk)
For a Denstep board (RED 7 segment display) "-" means that the servo power is off, check the 24v power supply i.e. fuses and the fuse on the Denstep board its self
For a Denstep board (RED 7 segment display) "-" means that the servo power is off, check the 24v power supply i.e. fuses and the fuse on the Denstep board its self