Hello.
I am new to the Denford forum. We have an old denford cnc machine that is labelled Triac PC. There is no problem with the CNC mill itself but the computer with the running software is dead. I would like to changeover and use Mach 3 with the system The problem is that even though I have worked with Mach 3 on a simpler system I developed before, I have no idea where and how to begin the changeover. I would not want to mess up the machine irreparably and would really appreciate guidance on how to proceed.
I have the manual with a few of the control panel components but I am not good at reading the.
Can anyone out there help me?
A picture of the the CNC mill is attached.
Regards,
Kui_2013
Triac PC
Moderators: Martin, Steve, Mr Magoo
-
angel-tech
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: Triac PC
where are you based ?