Hi all,
could anyone tell me if it is possible to connect vr milling to optimised controls smartMOVE servo controller instead of the smartstep?
as i can get a smartmove really cheap, i used to use them a lot in a former life!!
kindest regards
ian
smart move
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3636
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
Re: smart move
Is the smartMOVE RS232 based as well ?
Most functions will work if so, but bear in mind that we had special firmware so there could be commands or features which won't work (threading and move buffering were features in our firmware not available in the standard one at the time IIRC )
Most functions will work if so, but bear in mind that we had special firmware so there could be commands or features which won't work (threading and move buffering were features in our firmware not available in the standard one at the time IIRC )