NB, 16Mhz is the highest speed ever used.
Other clock speeds (eg, 14Mhz) will not work with some versions of the DOS firmware EPROM
How to locate clock crystal (Mhz) on Baldor rack board
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
How to locate clock crystal (Mhz) on Baldor rack board
This image shows what to look for when finding out what clock / crystal speed you have fitted to a Denford VME rack based control system:
NB, 16Mhz is the highest speed ever used.
Other clock speeds (eg, 14Mhz) will not work with some versions of the DOS firmware EPROM
NB, 16Mhz is the highest speed ever used.
Other clock speeds (eg, 14Mhz) will not work with some versions of the DOS firmware EPROM