Identify Machine Eprom

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Identify Machine Eprom

Post by Steve » Tue 13 Sep , 2011 11:19 am

On the control card there is an Eprom that dictates which software will run.

Some EPROMS will run with DOS software others will allow you to use VR Milling or Turning.

The EPROMS fitted are no longer available so Newer boards have a piggy back board fitted.

The attached photos show the Nextmove card and the EPROM, a close up of the EPROM and the new style unit.
Attachments
CLOSE UP OF EPROM FOR VR SOFTWARE.jpg
CLOSE UP OF EPROM FOR VR SOFTWARE.jpg (87.12 KiB) Viewed 2874 times
CONTROL CARD AND EPROM.jpg
CONTROL CARD AND EPROM.jpg (92.75 KiB) Viewed 2874 times
NEXTMOVE with NEW PIGGY BACK EPROM.jpg
NEXTMOVE with NEW PIGGY BACK EPROM.jpg (75.36 KiB) Viewed 2874 times
Top
Post Reply

Return to “Electronics”