Orac Toolchanger dc motor spec ?

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
cncbasher
CNC Apprentice
CNC Apprentice
Posts: 50
Joined: Tue 08 Jul , 2008 8:49 am

Orac Toolchanger dc motor spec ?

Post by cncbasher » Tue 17 May , 2011 20:55 pm

anyone have info on the dc motor used in the orac toolchanger

i'm looking at supplying a seperate dc supply , so wondered what volts / current rating it is

i presume the dc motor cover can be removed , although removing the 2 grub screws , i still cant slide the cover off
but just in case iv'e missed any other removal sequences , iv'e left it alone !

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Orac Toolchanger dc motor spec ?

Post by Denford Admin » Fri 20 May , 2011 8:38 am

It mentions it in here:
viewtopic.php?f=43&t=2963
MOTOR TRIDENT : 2332.912 11.151 000

Have you also checked the electrical drawings:
viewtopic.php?f=43&t=400

PS- there are two type of search - one at the top and one at the bottom of every page :wink:

Post Reply