North East Electronics SMCU installation and maintenance guide
NEE SMCU Installation Guide Version2 Oct 1987 OCR pdf
NEE SMCU Installation Guide Version2 Oct 1987 OCR pdf
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3634
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
NEE SMCU Installation Guide Version2 Oct 1987 OCR pdf
- Attachments
-
- NEE-SMCU-Installation-Guide-Version2-Oct-1987-OCR.pdf
- (4.39 MiB) Downloaded 2166 times
Re: NEE SMCU Installation Guide Version2 Oct 1987 OCR pdf
Love the minimum system requirements:
"DOS 2.0 or higher"
All of the old Denford applications used a customised version of the SMCU controller firmware (for things like the SMCU controlled Starmills and the Triacs "ATC Controller board") but the hardware should be pretty much the same as this doc.
"DOS 2.0 or higher"
All of the old Denford applications used a customised version of the SMCU controller firmware (for things like the SMCU controlled Starmills and the Triacs "ATC Controller board") but the hardware should be pretty much the same as this doc.