LYNX 08 THYRISTOR

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
jaycnc
CNC Apprentice
CNC Apprentice
Posts: 59
Joined: Wed 27 Aug , 2008 13:27 pm
Location: chesterfield

LYNX 08 THYRISTOR

Post by jaycnc » Sun 28 Mar , 2010 11:16 am

Does anyone know where i can lay my hands on a Thyristor Array for the Lynx 08 drive board please?
Iv tried RS,ebay and searching the net to no luck :(

Its the big black block that sits under the board between the board and heat sink.

thanks
jay
Top
jaycnc
CNC Apprentice
CNC Apprentice
Posts: 59
Joined: Wed 27 Aug , 2008 13:27 pm
Location: chesterfield

Re: LYNX 08 THYRISTOR

Post by jaycnc » Tue 30 Mar , 2010 5:21 am

Does no one know what part number this Thyristor is at all???? :(
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Re: LYNX 08 THYRISTOR

Post by Denford Admin » Wed 07 Apr , 2010 11:45 am

Have you tried Transdrive ?
viewtopic.php?f=47&t=2614
Top
Post Reply

Return to “Electronics”