RS232 recieve cable???????

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
-=PAB=-
CNC Apprentice
CNC Apprentice
Posts: 82
Joined: Mon 19 Jun , 2006 19:46 pm

RS232 recieve cable???????

Post by -=PAB=- » Wed 21 Jun , 2006 19:02 pm

is it right that i may need 2 rs232 cables one to send and one to recieve?? if so where can i find both drawings for these :?: :?: :?:
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 22 Jun , 2006 9:48 am

MrMagoo supplied some old machine cable diagrams you can download here:

http://www.denfordata.com/downloads/dos ... agrams.zip
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Thu 22 Jun , 2006 13:38 pm

Also, try out the old Industrial Text Editor-

see this post
http://denfordata.com/bb/viewtopic.php?p=699#699
Top
Post Reply

Return to “Electronics”