Need Help with Mpg for Fanuc ot d

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
sudhirudar
Posts: 7
Joined: Mon 02 Nov , 2009 10:04 am

Need Help with Mpg for Fanuc ot d

Post by sudhirudar » Thu 19 Nov , 2009 16:00 pm

Hi
I purchased a flat bed kirloskar with fanuc otd control.
It did not have a MPG now I want to put an mpg on the machine for which i need the circuit digram.
Any help will be appriciated.

User avatar
Denford Admin
Site Admin
Posts: 3642
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Need Help with Mpg for Fanuc ot d

Post by Denford Admin » Mon 23 Nov , 2009 16:17 pm

As we have never supplied an 0TD, we have no information to hand.

However, I have uploaded some relavant information from the 0TC / 0MC manual which may be the same on your system :?:

viewtopic.php?f=15&t=2474

Post Reply