Denford / Baldor control board evolution

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Denford / Baldor control board evolution

Post by bradders » Tue 13 Oct , 2009 6:49 am

How do I identify my Denford / Baldor control board and the software it will run?

User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Re: Denford / Baldor control board evolution

Post by bradders » Tue 13 Oct , 2009 6:49 am

1. Denstep board RED 7 Segment display, Orange Connectors, (RS232), VR Milling Ver 2
2. Nextstep board Green 7 Segment display, Orange Connectors, (RS232 / USB), VR Milling Ver 5 / VR Milling Ver 2
3. Nextstep board Green 7 Segment display, Black Connectors, (USB), VR Milling Ver 5
4. Nextstep board Orange 7 Segment display, Black Connectors, (ROHS), (USB), VR Milling Ver 5

User avatar
Steve
CNC Guru
CNC Guru
Posts: 1449
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Re: Denford / Baldor control board evolution

Post by Steve » Tue 13 Oct , 2009 8:12 am

I think the
3. Nextstep board Green 7 Segment display, Black Connectors, (USB), VR Milling Ver 5
will also run VR Milling 2

It is the Yellow RoHS compliant board that does not run the old firmware.

Post Reply