Customer writes .........
I have just bought a Novamill, vintage 1999, s/n 90804F from a school to use as an introduction to CNC milling in my hobby of model making. It appears to be complete and in good condition but minus PC and software. The chip fitted to the Denstep board is marked "DenMINT V2.0.b10/s/B19-JD5" and a second chip marked "ESMINT 3.28 V1.6H/S-JD5" was also with the machine.
EPROM Chip identification
Moderators: Martin, Steve, Mr Magoo
- bradders
- CNC Guru
- Posts: 1251
- Joined: Mon 13 Feb , 2006 12:35 pm
- Location: Brighouse, England
- Contact:
Re: EPROM Chip identification
"DenMINT V2.0.b10/s/B19-JD5" - The early Version for running VR Milling Ver2 superceded by Ver 2.1b6
"ESMINT 3.28 V1.6H/S-JD5" - For running Denford DOS software
"ESMINT 3.28 V1.6H/S-JD5" - For running Denford DOS software
-
- Posts: 11
- Joined: Thu 27 Oct , 2016 14:05 pm
- Hardware/Software: Hi,
I have faulty baldor D281 motion control card for a triac P. C. (denford). The firmware is ESMINT 3.28 V1.6H/S - JD5. We would like to purchase this card, is it still available? Please let me know as soon as possible, I need it urgently for students' semester projects.
Thank you.
Re: EPROM Chip identification
I have faulty baldor D281 optimised control card for a triac P. C. (denford). The firmware is ESMINT 3.28 V1.6H/S - JD5.
I have attached an image of the motion controller card. Please, we can we get a used/replacement/used one? Thank you.
I have attached an image of the motion controller card. Please, we can we get a used/replacement/used one? Thank you.