EPROM Chip identification

Information and questions about Denford CNC Control electronics, general electrical issues, cables, diagrams, stepper motors, drives etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

EPROM Chip identification

Post by bradders » Mon 06 Jul , 2009 11:13 am

Customer writes .........

I have just bought a Novamill, vintage 1999, s/n 90804F from a school to use as an introduction to CNC milling in my hobby of model making. It appears to be complete and in good condition but minus PC and software. The chip fitted to the Denstep board is marked "DenMINT V2.0.b10/s/B19-JD5" and a second chip marked "ESMINT 3.28 V1.6H/S-JD5" was also with the machine.

User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Re: EPROM Chip identification

Post by bradders » Mon 06 Jul , 2009 11:15 am

"DenMINT V2.0.b10/s/B19-JD5" - The early Version for running VR Milling Ver2 superceded by Ver 2.1b6
"ESMINT 3.28 V1.6H/S-JD5" - For running Denford DOS software

david
Posts: 11
Joined: Thu 27 Oct , 2016 14:05 pm
Hardware/Software: Hi,

I have faulty baldor D281 motion control card for a triac P. C. (denford). The firmware is ESMINT 3.28 V1.6H/S - JD5. We would like to purchase this card, is it still available? Please let me know as soon as possible, I need it urgently for students' semester projects.

Thank you.

Re: EPROM Chip identification

Post by david » Thu 27 Oct , 2016 15:31 pm

I have faulty baldor D281 optimised control card for a triac P. C. (denford). The firmware is ESMINT 3.28 V1.6H/S - JD5.

I have attached an image of the motion controller card. Please, we can we get a used/replacement/used one? Thank you.
Attachments
e12.pdf
Motion controller card (view 2)
(156.97 KiB) Downloaded 499 times
e11.pdf
Motion controller card (view 1)
(143.75 KiB) Downloaded 518 times

Post Reply