Denford Software & Machines • View topic - How to change the Top Card on the NextMove controller.

View unanswered posts | View active topics

Board index » CNC / Machines » Electronics

All times are UTC [ DST ]

How to change the Top Card on the NextMove controller.

Moderators: Martin, bradders, Steve, Mr Magoo

Page 1 of 1

[ 1 post ]

Print view

Previous topic | Next topic

Author

Message

Steve

Post subject: How to change the Top Card on the NextMove controller.

Posted: Fri 29 Jan , 2010 15:27 pm

CNC Guru

Joined: Tue 21 Feb , 2006 16:15 pm
Posts: 763
Location: Denford UK

The top card on all the controllers supplied from Smartstep, Denstep to NextMove can all be replaced in the same way.

Wether upgrading to a newer top card or fitting a service replacement the principle is the same.

Attached is a PDF booklet that tells you how to do this.

The PDF should be printed back to back then folded in half then stapled.

Attachments:

Nextmove top card replacement.pdf [519.49 KiB]
Downloaded 55 times

Top

Page 1 of 1

[ 1 post ]

Board index » CNC / Machines » Electronics

All times are UTC [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: