I am trying to interface a breakout board to the step and direction inputs on the original drives.
Could someone describe what is required.
orac original stepper drives
Moderators: Martin, Steve, Mr Magoo
-
Denford Admin
- Site Admin
- Posts: 3642
- Joined: Fri 10 Feb , 2006 12:40 pm
- Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then. - Location: Sunny Brighouse
- Contact:
-
Barry_Scott
- Posts: 4
- Joined: Tue 17 Jan , 2012 13:05 pm
Re: orac original stepper drives
is there a difference in how they process the incoming signal?
-
angel-tech
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: orac original stepper drives
the step and direction points are in different places
-
Barry_Scott
- Posts: 4
- Joined: Tue 17 Jan , 2012 13:05 pm
Re: orac original stepper drives
What i need to know is what input are they expecting.
+5v +12v +24v
how much current is required.
+5v +12v +24v
how much current is required.
-
angel-tech
- CNC Guru
- Posts: 525
- Joined: Tue 14 Nov , 2006 12:12 pm
- Hardware/Software: .....
4 Quatros
3 Oracs
2 Easiturn atc
12 station lathe atc
Mach 3 - Location: Quatroland
Re: orac original stepper drives
12v, and if you do a search on here for digiplan there's a circuit describing how to drive the step and direction inputs from a parallel port