ZeroTurn

Any information regarding the Denford ZeroCentre ZeroTurn ZeroBore Fanuc CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
inovar
Posts: 4
Joined: Fri 22 Mar , 2013 17:39 pm
Hardware/Software: Denford Zeroturn S/NZT-10097A Fanuc OT control
Location: Perth Australia

ZeroTurn

Post by inovar » Fri 19 Feb , 2016 8:40 am

Can anyone help with an issue I am having when trying to start the machine. When I throw the main switch I get an "AL-19" alarm on the small Mode/date panel. I have had some success by pressing all 4 of the setting buttons as I throw the main switch and manage to get the machine running sometimes. When I fire up the Operating screen I see "Spindle Drive Fault" but cannot find any information regarding this. Any help will be most welcome.

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: ZeroTurn

Post by Martin » Fri 19 Feb , 2016 15:43 pm

can you post a picture of,,
"AL-19" alarm on the small Mode/date panel
.

inovar
Posts: 4
Joined: Fri 22 Mar , 2013 17:39 pm
Hardware/Software: Denford Zeroturn S/NZT-10097A Fanuc OT control
Location: Perth Australia

Re: ZeroTurn

Post by inovar » Fri 26 Feb , 2016 11:14 am

Thanks for the response Martin. Here is the image.
IMG_0722.JPG
IMG_0722.JPG (424.11 KiB) Viewed 9288 times

Martin
CNC Guru
CNC Guru
Posts: 1897
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: ZeroTurn

Post by Martin » Fri 26 Feb , 2016 14:23 pm

I can't find a manual for it but have found a list of fault codes online that says Excessive U phase current detection circuit offset

http://fanuc.pennineuk.com/spindle-alarm-codes.htm

inovar
Posts: 4
Joined: Fri 22 Mar , 2013 17:39 pm
Hardware/Software: Denford Zeroturn S/NZT-10097A Fanuc OT control
Location: Perth Australia

Re: ZeroTurn

Post by inovar » Fri 26 Feb , 2016 17:27 pm

Hey thanks Martin. I will get my Fanuc serviceman look into that.
You have been most helpful.

Best regards
Les

Post Reply