Force Limits

Any information regarding the Denford ZeroCentre ZeroTurn ZeroBore Fanuc CNC machines

Moderators: Martin, Steve, Mr Magoo

Post Reply
ColinH
Posts: 1
Joined: Wed 11 Aug , 2010 14:15 pm
Hardware/Software: Zerocentre

Force Limits

Post by ColinH » Mon 16 Aug , 2010 15:18 pm

I am interested in Finding out what the maximum Forces are in Newtons (N) that a ZeroCentre could tolerate are
in the X,Y,l (table directions) and expecially Z directions as I wish to use the machine for incremental forming.

Any suggestions on this or the motor/bearing specifications?

cheers,

Colin

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Re: Force Limits

Post by Denford Admin » Mon 16 Aug , 2010 15:58 pm

Sorry but I haven't seen any parts listings for the Zerocentre - only the Zeroturn.
I believe the Zerocentre carcass was imported from Taiwan and retrofitted by us.
I'll post the Brochure and anything else I find.

Post Reply