New kid with TDS3 CM&WL
Posted: Fri 17 Jul , 2020 13:31 pm
Hi all, new on here. I have a model of the subj lathe which came from a school to me via one of the Faberge family and my dad. It's in reasonable shape and largely original except for a single phase motor and t-slotted cross slide.
I am contemplating the addition of an ELS set up in order to extend its usability (for me). This would probably require coolant. Can anyone point me in the direction of a dimensioned drawing for part ML124 (a or b) Splash Guard?
Having trawled through the available documents I cannot find one.
Thanks in advance,
Andy
I am contemplating the addition of an ELS set up in order to extend its usability (for me). This would probably require coolant. Can anyone point me in the direction of a dimensioned drawing for part ML124 (a or b) Splash Guard?
Having trawled through the available documents I cannot find one.
Thanks in advance,
Andy