TDS 1/1 single phase wiring

All info relating to Viceroy machines - Lathes, sharpedge, drills etc...

Moderators: Martin, Steve, Mr Magoo

Post Reply
dakes55
Posts: 25
Joined: Tue 24 Jan , 2017 20:50 pm
Hardware/Software: Denford Viceroy TDS 1/1 GBL

TDS 1/1 single phase wiring

Post by dakes55 » Sat 25 Mar , 2017 15:53 pm

Hi, I am converting my lathe to single phase, I have downloaded the wiring diagram for the TDS 1/1 and need some advice please, on the single phase wiring diagram it shows 4 wires going to the motor these are X,Y,B and A, does anyone know where these would be wired to on the motor side, my motor is a Brook Crompton with terminals marked A-Z-Z1 and S

LesT
CNC Expert
CNC Expert
Posts: 117
Joined: Wed 11 Aug , 2010 14:17 pm
Hardware/Software: An old Viceroy with a half installed invertor drive,(when I can decide where to put the control pushbuttons I will wire it up properly)
A WMD25V mini mill.
Tractor, Bobcat 320, and Dumper truck.
7 sheds, about 5 (?) mowers. etc, etc.
Location: Scotland !

Re: TDS 1/1 single phase wiring

Post by LesT » Sat 25 Mar , 2017 17:05 pm

This might help ...
http://bbs.homeshopmachinist.net/thread ... -terminals

(See post #5)

Les.T.

Post Reply