image shifting while machine still running

Help, advise and examples created by the Universal Laser Systems (ULS) VersaLaser laser cutting / marking machine supplied by Denford

Moderators: Martin, Steve, Mr Magoo

Post Reply
sanju
Posts: 19
Joined: Tue 27 Feb , 2007 9:23 am
Location: KENYA

image shifting while machine still running

Post by sanju » Mon 19 Mar , 2007 14:34 pm

What causes the image to shift from one location to another while the machine is running? You find that halfway while the job is running, the image shifts to right hand side and continues. Sometimes the machine starts banging as the lense does not 'sense' home position.

User avatar
Denford Admin
Site Admin
Posts: 3632
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:

Post by Denford Admin » Mon 19 Mar , 2007 17:14 pm

We have seen these symptoms before with some computers which have some hardware problems with the USB ports.

We had this exact problem with some brand new DELL C521 PC's
The USB ports seemed to start sending garbage to the machine after around 10 minutes into the job - it seemed to work fine for small / shorter jobs, but went crazy after a while.

We fixed it by fitting an additional PCI USB card to the computer. This card was based on NEC USB chips.

Its also worth checking the Versalaser software is up to date, and that the USB cables are good quality.

If all this fails, then you will need an engineer to inspect and possibly change the control card inside the laser.

User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Post by bradders » Mon 19 Mar , 2007 17:15 pm

Maybe the air assist hose is causing it to slip. Sometimes the air assist hose will develop memory and curve out of the channel it runs in. This will then get in the way of the focus carriage. You can have them try to turn the hose a little and see if they can get it out of the way and run in the channel better.

Post Reply