Versa Laser fume extraction not working

Help, advise and examples created by the Universal Laser Systems (ULS) VersaLaser laser cutting / marking machine supplied by Denford

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Versa Laser fume extraction not working

Post by bradders » Thu 23 Feb , 2006 11:40 am

Versa Laser fume extraction not working and smoke is filling the working area
Last edited by bradders on Mon 16 Oct , 2006 16:27 pm, edited 1 time in total.

User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:

Post by bradders » Thu 23 Feb , 2006 11:40 am

Replace the 5 Amp fuses with 6.3 Amp "time lag" (Slo-Blo) fuses.

Note ! On the bottom right hand side of the back of the Versalaser (when viewed from the rear) there is a kettle plug socket built into the fan unit. Remove the kettle plug and to the right of the socket is the fuse holder.
Press both tabs towards each other and pull out the fuse holder, check with an electrical meter to see if the fuse/s have blown and replace with 6.3 Amp "time lag" (Slo-Blo) fuses.

Post Reply