We have versaLASER V300 and want to cut 6mm foam board.
Please can you advise on suitable settings to cut without burning the core.
VersaLASER foam board cutting settings
Moderators: Martin, Steve, Mr Magoo
VersaLASER foam board cutting settings
holtlanerg411ee
I have not tried to cut foam board before but would suggest you try either selecting a very soft material and see how it cuts. If it does not cut through try increasing the intensity or a different material setting.
You could also try two passes over the same part or deep engraving (on a blue line) for somthing like Perspex.
To get the right settings for any material is all a bit trial and error. Just draw a small simple shape and see what happens. Start with the lowest settings and work up.
You could also try two passes over the same part or deep engraving (on a blue line) for somthing like Perspex.
To get the right settings for any material is all a bit trial and error. Just draw a small simple shape and see what happens. Start with the lowest settings and work up.
- bob-in-dav
- Posts: 1
- Joined: Sun 24 Jun , 2007 11:22 am
- Location: Daventry Northants
This response is probably much too late but others may be interested too.
I have managed to cut 6mm foamboard on the Versalaser with the material setting on "Balsa Wood"
However - the foam core shrinks back significantly with the heat giving an inward radius to the finished cut.
Give it a try - it might be OK for your application.
I have managed to cut 6mm foamboard on the Versalaser with the material setting on "Balsa Wood"
However - the foam core shrinks back significantly with the heat giving an inward radius to the finished cut.
Give it a try - it might be OK for your application.