Denford Software & Machines

Denford Software & Machines

 
 

Denford Software & Machines

Welcome to the Denford CAD CAM CNC forum


Hint - Try the google search at the bottom of the page
It is currently Mon 23 Oct , 2017 1:42 am

All times are UTC [ DST ]




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: Advantage 3 Extraction- 3 flashing LEDs
PostPosted: Fri 08 Mar , 2013 19:19 pm 
Offline

Joined: Fri 08 Mar , 2013 19:15 pm
Posts: 4 Hardware/Software: VL-200 Laser and Advantage 3
Hi , our extraction unit has three flashing LEDs when it is turned on. The unit sounds fine , but it fails to extract fumes and smoke. The filters were replaced around 4 months ago and are not blocked. I removed the rear outlet pipe from the the VL-200 and there didn't seem to be a great deal of suction ( if any) .

Any ideas?



Regards

RM Teacher


Top
 Profile  
 
 Post subject: Re: Advantage 3 Extraction- 3 flashing LEDs
PostPosted: Sat 09 Mar , 2013 9:31 am 
Offline
CNC Guru
CNC Guru

Joined: Fri 24 Feb , 2006 17:09 pm
Posts: 1501
Location: Brighouse
viewtopic.php?f=5&t=4065


Top
 Profile  
 
 Post subject: Re: Advantage 3 Extraction- 3 flashing LEDs
PostPosted: Sat 09 Mar , 2013 12:33 pm 
Offline

Joined: Fri 08 Mar , 2013 19:15 pm
Posts: 4 Hardware/Software: VL-200 Laser and Advantage 3
Thank you for the reply. I will take a look at the fuses - where about are they located in the unit?


Top
 Profile  
 
 Post subject: Re: Advantage 3 Extraction- 3 flashing LEDs
PostPosted: Sun 10 Mar , 2013 13:28 pm 
Offline
CNC Guru
CNC Guru

Joined: Fri 24 Feb , 2006 17:09 pm
Posts: 1501
Location: Brighouse
Behind the cover on the left hand side. You will need a 3mm allen key to remove it.


Top
 Profile  
 
 Post subject: Re: Advantage 3 Extraction- 3 flashing LEDs
PostPosted: Sun 10 Mar , 2013 14:12 pm 
Offline

Joined: Fri 08 Mar , 2013 19:15 pm
Posts: 4 Hardware/Software: VL-200 Laser and Advantage 3
Thank you Martin. I will take a look tomorrow , is there anything else I should look for? The diagnostic notes are a little vague.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Template made by DEVPPL
[ Time : 0.119s | 14 Queries | GZIP : Off ]
 
Loading