Is our Versalaser fixable?
Posted: Mon 17 Dec , 2012 13:51 pm
Hi,
I now realise the importance of not walking away from a running laser cutter as I came back to find ours on fire. The lid on our VL200 is now very damaged and the x-axis belt has burnt and is now far too loose. Does anyone know if these can be replaced?
Any advice would be greatly appreciated.
I now realise the importance of not walking away from a running laser cutter as I came back to find ours on fire. The lid on our VL200 is now very damaged and the x-axis belt has burnt and is now far too loose. Does anyone know if these can be replaced?
Any advice would be greatly appreciated.