Denford Software & Machines

Denford Software & Machines

 
 

Denford Software & Machines

Welcome to the Denford CAD CAM CNC forum


Hint - Try the google search at the bottom of the page
It is currently Mon 23 Oct , 2017 1:38 am

All times are UTC [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Rotary Fixture FAQ
PostPosted: Fri 01 Oct , 2010 15:46 pm 
Offline
Site Admin
User avatar

Joined: Fri 10 Feb , 2006 12:40 pm
Posts: 3573
Location: Sunny Brighouse Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Rotary Fixture FAQ
Question
- Answer

What kinds of operational checks can I do to ensure that my Rotary Fixture is working right?
- Make sure that when you install the rotary in the table socket that the cone briefly rotates.
- Verify that when you click “Rotary” in the focus tab of the VCP that the red diode is close to the centerline of the Rotary.
- Be sure to have “Rotary Fixture” selected in the Fixture Type selection menu.


What kind of adjustments can I make help optimize my Rotary fixture?
- Always check the focus of each object being engraved with the rotary.
- Measure the diameter accurately and enter the value in the driver.

What if my system will not detect the Rotary Fixture?
- Be sure the rotary has been set into the table socket connector completely.
- Be sure that “Rotary Fixture” is selected in the Fixture Type selection menu.

What is the best way to clean and maintain my Rotary Fixture?
- Use light industrial cleaner to keep the cone clean and the base free of debris.


Top
 Profile  
 
 Post subject: Re: Rotary Fixture FAQ
PostPosted: Tue 12 Oct , 2010 13:39 pm 
Offline
Site Admin
User avatar

Joined: Fri 10 Feb , 2006 12:40 pm
Posts: 3573
Location: Sunny Brighouse Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
There is also some info here on using CorelDraw with the rotary engraving fixture:
viewtopic.php?f=5&t=3078


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Template made by DEVPPL
[ Time : 0.106s | 14 Queries | GZIP : Off ]
 
Loading