Post subject: Versalaser CPU Initialization auto Z and rotary calibration
Posted: Thu 06 Dec , 2007 11:47 am
Site Admin
Joined: Fri 10 Feb , 2006 12:40 pm Posts: 3581 Location: Sunny Brighouse
Hardware/Software: Go to User Control Panel > Profile Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Joined: Fri 10 Feb , 2006 12:40 pm Posts: 3581 Location: Sunny Brighouse
Hardware/Software: Go to User Control Panel > Profile Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
** Please note that this information is provided as is, and we take no responsibility for events arising from its use or mis-use **
Post subject: Re: Versalaser CPU Initialization auto Z and rotary calibrat
Posted: Fri 08 Nov , 2013 17:37 pm
Joined: Sun 22 Apr , 2012 19:24 pm Posts: 33
Hi Just reading how to reset and am a little confused at Step 4 on the pdf. It says if you have purchased proceed to step 6. Which wants you to set the 1.5 lens up. Surely this should read If you have not purchased other lens kits, skip to step 6
Users browsing this forum: No registered users and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum