Reinstall new VLS software over old VLS software

Help, advise and examples created by the Universal Laser Systems (ULS) VersaLaser laser cutting / marking machine supplied by Denford

Moderators: Martin, Steve, Mr Magoo

Post Reply
User avatar
bradders
CNC Guru
CNC Guru
Posts: 1251
Joined: Mon 13 Feb , 2006 12:35 pm
Location: Brighouse, England
Contact:
Contact bradders

Reinstall new VLS software over old VLS software

Post by bradders » Wed 06 Jun , 2007 14:08 pm

This is the procedure to reinstall new VLS software over old VLS software

1. Unplug the USB cable from the Laser
2. Uninstall the old VLS Versa Laser Software
3. Install the new VLS Versa Laser Software
4. Uninstall the new VLS Versa Laser Software
5. Reinstall the new VLS Versa Laser Software
6. Reconnect the USB cable
Top
User avatar
Denford Admin
Site Admin
Posts: 3634
Joined: Fri 10 Feb , 2006 12:40 pm
Hardware/Software: Go to User Control Panel > Profile
Enter as much information about your CNC hardware and software as you can - it makes it easier for everyone to know what you're talking about then.
Location: Sunny Brighouse
Contact:
Contact Denford Admin

Post by Denford Admin » Fri 22 Jun , 2007 9:43 am

Note - ignore this for VL laser drivers / machines
VLS is the NEW series of laser
Top
User avatar
Steve
CNC Guru
CNC Guru
Posts: 1432
Joined: Tue 21 Feb , 2006 16:15 pm
Location: Denford UK

Post by Steve » Fri 22 Jun , 2007 16:54 pm

THIS ONLY HAS TO BE DONE IF YOUR DRIVER IS PRIOR TO 2.12.12

THE VERY EARLY DRIVER LEFT FILES INSTALLED THAT WERE NOT REMOVED BY THE UPGRADE.
Top
Post Reply

Return to “VersaLaser”