New Turn 270NS is the middle of editing are

All info relating to the Denford Turn270 and NewTurn270 CNC lathes

Moderators: Martin, bradders, Steve, Mr Magoo

Post Reply
rs-tackle
Posts: 1
Joined: Sat 02 Apr , 2016 21:32 pm
Hardware/Software: NewTurn 270NS / VS Turn

New Turn 270NS is the middle of editing are

Post by rs-tackle » Sat 02 Apr , 2016 21:38 pm

Hello

I have the following problem with my New Turn 270NS

no matter what program I will run automatically remains in the second embodiment , the machine in the middle of the processing of the feed are then the software must be restarted and then it runs again 1 times by the second time again the same .

if after the stop time Stop is pressed , then back to start a sentence is always executed although automatic mode is selected .

what can I do ?

Martin
CNC Guru
CNC Guru
Posts: 1706
Joined: Fri 24 Feb , 2006 17:09 pm
Location: Brighouse

Re: New Turn 270NS is the middle of editing are

Post by Martin » Mon 04 Apr , 2016 10:28 am

Can you post a video of what is happening?

Can you also check you are getting spindle speed feedback on the control panel.

Post Reply