Denford Software & Machines

Hey

i have trouble changing the PWE parameter. i have put the "Program Lock Key" to off,put the machine in "MDI" mode and i have even tried to put the Emergency button in to se if that helps. but nothing.
is there anything im missing?? is there another parameter i can change.

the reason is that i want to hange the diag parmater 127.5 to 1 to try and see if i can get the DripFeed to work.

edit:
would like to add that i cant run the macine in mdi mode where i punch one command at a time. since its 5 years since i touched it last. i kinda starting all over again

Does it change if you are in EDIT mode?

no, it dosent matter wich mode i'm in. is there anyway to block for writing other than key??

I got to change the PWE, it was the ATC that had a hidden fault, that didnt show as an alarm.

Just to check the g127.5 is a diagnostic not a parameter setting??

Tried to change the diag 127 from 00000100 to 00010000, but after pressing input nothing changed??
Any thoughts??

The mdi singel part i can now put in commands but not execute them??

Is there another gidde fault that is possible in this machine??