Page 1 of 1


Posted: Sun 23 Jun , 2019 19:47 pm
by jeremydraper
How accurate is my Denford Triac ?

I would like to fit a high speed spindle so I can do engraving.

I have been asked what accuracy can I hold on my machiner but I am unsure what to reply.

Re: accuracy

Posted: Sat 29 Jun , 2019 7:27 am
by Steve
Resolution will be down to 0.01m

The accuracy is difficult to quantify as this is a potential worse case scenario depending on the tolerances os all the parts.

Repeatability should be within 0.05