Fanuc Triac Overtravel Alarm
Posted: Thu 08 Oct , 2015 14:35 pm
Hi I have recently bought a Fanuc Triac Machine, I have it all connected in my workshop but am unable to home it.
When I turned I have a Y overtravel alarm.
The table does seem very far forward.
I have tried using the axis override button but it does not clear the 'not ready' flashing on the screen or allow me to jog the axis.
The P+Can trick also didn't work.
Could someone also confirm the process for homing the machine as the manual isn't too clear on this.
When I turned I have a Y overtravel alarm.
The table does seem very far forward.
I have tried using the axis override button but it does not clear the 'not ready' flashing on the screen or allow me to jog the axis.
The P+Can trick also didn't work.
Could someone also confirm the process for homing the machine as the manual isn't too clear on this.